Basic operation

Create the hard disk

To create a hard disk, you can enter the operation interface through both the hard disk page and the instance page. This example is the steps of entering the hard disk page.

1. Sign in to the console.
2. On the left navigation bar, select "Product" - "Blok storage".
3. Click "Add" to create hard disk.
4. Set the hard disk configuration in the hard disk creation interface, and support the use of snapshots in the same region and the same availability zone to create hard disks.
5. Confirm the configuration information and cost, then confirm the deployment of hard disks.
6. After the creation is successful, return to the hard disk list page.

Rollback hard disk with using snapshot

1. Log in to the console.
2. In the left navigation bar, select "Product" - "Snapshot".
3. Select the target snapshot on the snapshot page and perform the operation "Take snapshot".
4. Click "Submit" in the pop-up dialog box to complete the rollback.

Increase hard drive capacity

1. Sign in to the console.
2. On the left navigation bar, select "Product" - "Block storage".
3. Select the target hard disk, and click "Add".
4. In the pop-up dialog box, click Configure new capacity, and click "Submit" to complete the capacity increase.

Delete the hard disk

1. Sign in to the console.
2. On the left navigation bar, select "Product" - "Block storage".
3. Select the target hard disk on the hard disk page and operate "Delete".
4. In the pop-up dialog box, after confirming the information, click "Submit" to complete the release.